Emco F1 cnc mill, milling machine

Emco F1 cnc mill, milling machine

When we bought this machine it was in new condition, and we only used it four or five times to mill aluminum and drill into some steel plates. It can be run stand-alone, as we did, with G and M code programing from it's keypad, OR you could interface it with a PC. There is a small tape drive for storage.
The tool holders are CAT-30 type and snap in and out with the twist of a lever. It has five tool holders and they are all CAT-30 with changeable collets.
The bed and table of the mill are cast iron and it has an automatic vise. We added a switch to manually control the vise, a coolant switch and a panic stop button. We ran it with mist coolant.
There are two electronic boxes / monitor that may have been supplied by EMCO to interface the mill with a lathe and robot but we haven't used them so I'm not sure what they were for.
This mill comes with its original users manual.