Sheldon, monarch jr. or rivett lathe leather drive belt

Sheldon, monarch jr. or rivett lathe leather drive belt

This belt will be custom made for a Sheldon, Monarch Jr., South Bend or Rivett Lathe. It will be made to a 34” to 40” length, depending on your machine, & 1-1/4” wide, single ply (11/64” thick) made of top quality back cut leather. It will come with Clipper clip belting fasteners & a Nylon connector pin for connecting once it is installed. This new belt will come with instructions or suggestions, for installation, which side to run on pulley & recommended direction it should be run.