Complete cti high vacuum cryopump & compressor system

Complete cti high vacuum cryopump & compressor system

1 ea CTI Cryogenics Cryo-Torr 8 Cold Head (glass cracked on diode gauge, guages works fine, does not affect functionality)
1 ea 8300 CTI Cryogenics Compressor
1 ea 8004 CTI Cryogenics Controller
1 ea Control, Compressor, and Cold Head interface Cables.
4 ea Helium Lines( 2 lines were used in the system, and 2 were spares(spares were not tested for He leaks))
1 ea He Decontamination Manifold
1 ea Spare Helium line oil Adsorber
1 ea Cryo Head and Crompressor Installation, Operation and Servicing Instruction Manual
MISC : poppet valve components, vent cap, He connection seals
This was removed from my vacuum system, and was only occasionaly used to pump the system under high vac. No aggressive gases were used in the system. It was newly rebuilt before I started using it and I only put about 200 hrs on it.
The Cryopump has an ASA flange and can be mounted in any orientation. The compressor, cold head and lines were all charged when dissembled and there were no Helium leaks. The cold head has a Poppet vent and a N2 purge stick.
The System runs on 198 - 250 VAC 50/60 HZ 2.2kw Single Phase. The compressor requires water cooling.
There are a spare set of Helium lines, adsorber, Half a control cable, and misc parts.
There is a 15k and 80k array rebuild kit, and a Helium decontamination manifold, for use to decon the system if needed.
If you've been looking to get into a complete cryo pumped package or are looking for a complete set of spares, then this is what you need.
Can be used on applied materials amat varian like ebara leybold