Armstrong lathe tool holders cut off & boring set of 3

Armstrong lathe tool holders cut off & boring set of 3

Armstrong Lathe Tool Holders – Cut Off Bit Holders (#22 & #32) and Boring Bar Holders (one each)
These tools have various small marks, dings and/or light surface rust from age and use, and may have extra bits of paint here and there.
The shanks on these tool holders are approximately:
Holder #22: 5/8 inhces thick and 1 & 71/162 inches high.
Holder #32: 5/8 inches thick and 1 & 5/16 inches high.
Boring Bar Holder: 9/16 inches thick and 1 & 5/16 high. The round bar hole is 7/8 inches dia.
They look to be in good usable condition.