Complete logic prototyping system with power supply

Complete logic prototyping system with power supply

THIS IS A COMPLETE LOGIC PROTOTYPING SYSTEM WITH PLUG BOARD, POWER SUPPLY, ICs, LEDs, WIRE, AND RESISTORS.
1. PLUG BOARD WITH POWER SUPPLY. 500MA FUSE INLINE.
2. 6 LEDS, 2-RED, 2-GREEN, 2-YELLOW - LONG LEAD ANODE
6. 2 EACH 74ACT163 - 4 BIT COUNTERS
7. POWER SUPPLY LOGIC 5 VOLTS BUSSED TO THE PROTO BOARD. THERE IS ALSO A 12 VOLT AT 1 AMP AVAILABLE AS VB.
8. SET OF WIRES FOR INTERCONNECTING DEVICES ON THE PROTO BOARD.
THIS SHOULD GET YOU STARTED - JUST MAKE UP A TRUTH TABLE FOR THE DEVICE YOU ARE USING AND SET UP THE INPUTS USE THE LEDS TO INDICATE OUTPUTS. REMEMBER TO PUT A 150 OHM RESISTOR IN SERIES WITH THE LED OTHERWISE YOU WILL DESTROY THE LOGIC OUTPUT OF THE DEVICE. THE PLUS 5 VOLTS IS FUSED AT 500 MILLIAMPS TO PROTECT YOUR PROTOTYPE SYSTEM FROM SHORT CIRCUITS.