Zentech 101 lcr 4 point bridge bench meter w/ d & q

Zentech 101 lcr 4 point bridge bench meter w/ d & q

Zentech 101 LCR 4 point bridge meter
l Basic Measurement Accuracy 0.2%
l Bias Voltage can be applied from 0V to
l Guarded Four-Terminal Kelvin
l Connections to maintain Measurement
l Cost effective solution for LCR Testing
l Normal value setting for Δ% display
l Measurement auto-ranging or hold range
l Series/Parallel circuit mode selectable
The Zentech 100 and 101 LCR meters are the instruments capable of measuring the primary parameters of inductance (L), capacitance (C), Resistance (R), and the secondary parameters of dissipation factor (D) and quality factor (Q). The 101 has built in normal value setup function (Δ%), and is designed with maximum flexibility as well as operation convenience in mind.
The simple front panel of Zentech 100/101 LCR Meter requires less effort to operate. Its digital display and user friendly control allow test parameters and limits to be set easily. The Zentech 100/101 LCR Meter is an economical, user friendly, general-purpose meter for production test of inductors,
capacitors and other LCR components. The 100/101 performs the primary measurements of L, C, and R and the secondary measurements of D and Q. L, C, and R, which are done at the frequency of 120Hz or 1kHz with a basic accuracy of ± 0.2%. The accuracy of the secondary parameters for D or Q < 1 is ±0.001 for Q (with R), ±0.01 for Q (with L), and ±0.0005 for D (with C). Refer to the specifications for the accuracy of D and Q when D or Q > 1. Bias Voltage can be applied to capacitors by connecting an external voltage source on the rear panel. Bias levels from 0V to 35V DC are attainable. Two testing signal levels (0.25V/1V), two testing frequencies (120Hz/1kHz), selectable series/parallel circuit modes and three measurement speeds enable you to create your own test conditions.
An internal zeroing function is provided and selectable from the front panel. Auto/Manual ranging is selectable for the five measurement ranges. Connection to the device under test (DUT) is through 4 BNC terminals on the 100/101 front panel units.
Various test fixtures are provided for different device under test to improve the
measurement throughput and reliability.
Zentech 101 bench top LCR tester x 1
Kelvin Test lead ( 4 point BNC) x 1
FREE SMD clip ( 4 point BNC) x 1
For warranty parts and service:
All purchased are final, will replace defective product only.
Return package must be in the original packaging, everything must be in new condition. Missing partÂ’s or anything in original contact will not qualify for any refund.
Defective item can be exchanged within 7 days of receipt.
Replacement and refunds will not be processed until the return item received.